Loading presentation...

Present Remotely

Send the link below via email or IM

Copy

Present to your audience

Start remote presentation

  • Invited audience members will follow you as you navigate and present
  • People invited to a presentation do not need a Prezi account
  • This link expires 10 minutes after you close the presentation
  • A maximum of 30 users can follow your presentation
  • Learn more about this feature in our knowledge base article

Do you really want to delete this prezi?

Neither you, nor the coeditors you shared it with will be able to recover it again.

DeleteCancel

Lockout/Tagout

No description
by

Samuel Cantu

on 12 August 2015

Comments (0)

Please log in to add your comment.

Report abuse

Transcript of Lockout/Tagout

LOTO Placarding
Individual Locks
Each person working on equipment should have their own lock on the device.
Lockout/Tagout
Questions?
Purpose
Minimum Requirements for the lockout of energy isolating devices
Including:
Prevent inadvertent operation or energization of equipment or process to protect the worker

Establish methods for a zero energy state

Comply with Regulatory Standards
29 CFR 1910.147
Energy Sources
electrical,
mechanical,
hydraulic, pneumatic,
energy stored in springs,
potential energy from suspended parts (gravity)
radiation,
thermal,
compressed air,
chemical,
1. NOTIFY & IDENTIFY
LOTO SEQUENCE
2. SHUTDOWN EQUIPMENT
3. ISOLATE
4. LOCK & TAG
6. VERIFY POWER
5. RELEASE ENERGY
7. PERFORM SERVICE
8. REMOVE LOCKS
Notify all affected employees of a planned lockout and the reason for doing so
Shut down equipment using normal stopping procedure
Lockout energy isolating devices with an assigned individual lock
Release stored energy from:
Electrical systems
Hydraulic systems
Air, gas, steam or water pressure
Mechanical or kinetic sources
Operate push buttons to confirm equipment will not operate

Multimeter can be used for electrical systems
Maintenance or service on equipment can begin

No one can start the
machinery or equipment while it is being repaired or cleaned
Check equipment to see that no one is exposed

Remove locks and restore power
Some procedures are posted on the equipment
When to use LOTO
Service or Maintenance
Installation
Inspection
Cleaning
Modification
Lubrication
Un-Jamming
If guarding needs to be removed

When worker need to place any part of body into machinery
Definitions
Authorized Personnel:
Perform service and maintenance, apply locks and tags

Affected Personnel:
Operate the machinery, prepare machines/equipment, and work within same area where LOTO occurs

Other:
May pass by an area where LOTO is being used (office worker).
Devices
LOTO
Does Not Apply
Routine adjustments
Repetitive adjustments
Working on cord & plug equipment kept in sight
Integral with production
Always be Safe
Written
Procedures
Install device to isolate energy
Full transcript