Loading presentation...

Present Remotely

Send the link below via email or IM

Copy

Present to your audience

Start remote presentation

  • Invited audience members will follow you as you navigate and present
  • People invited to a presentation do not need a Prezi account
  • This link expires 10 minutes after you close the presentation
  • A maximum of 30 users can follow your presentation
  • Learn more about this feature in our knowledge base article

Do you really want to delete this prezi?

Neither you, nor the coeditors you shared it with will be able to recover it again.

DeleteCancel

OrthoGraph Architect - Floating Islands

A short prezi about how to add new rooms when the simple sketch&tap is not applicable
by

Laszlo Toth

on 4 February 2013

Comments (0)

Please log in to add your comment.

Report abuse

Transcript of OrthoGraph Architect - Floating Islands

OrthoGraph room structure
- Floating Islands You can add connected rooms in OrthoGraph simply by sketching their walls, and tapping inside them.

Sometimes it is not possible, as the rooms might not connected, they are inside each other, or it is simply more handy/precise to use this method.

In this case we have to create another room in the room structure, keeping in mind the concept of:

"Always work on the room where you are standing in!" Adding the 2nd Room - Floating Islands Create and measure the floor plan of the second room as learned before in the 1st steps prezi. Drawing the 2nd Room Don't forget to place and measure doors & windows like you did in the first room. Doors in the 2nd room When you are done with the second room, then assign it to the first one through the door. Select the Assign Doors feature to select both sides of the same door. Assigning Rooms Entering wall thickness, the two rooms will be attached to each-other.

This is named "Floating Islands", another important concept of OrthoGraph. Setting Wall Thickness There are walls measured from both rooms of the same wall. Identify them simply by using the Assign Walls function. OrthoGraph will replace the two walls with one with correct, measured thickness. This will be useful also by the further use of the drawings in CAD applications. Assign Wall Sides Repeat the procedure as long as you are ready with measuring the floor plan of the building. Create the Full Floor Plan There are many-many more features of the system like CAD integration to DWG, SketchUp or ArchiCAD, supporting foot/inch or meter etc.

To learn OrthoGraph Architect in details please check our 1st steps prezi (http://bit.ly/OGAfst) and our YouTube channel (http://bit.ly/OGYouT). More about OrthoGraph Architect In OrthoGraph there are two ways of adding rooms, the simple way (Sketch&Tap) is described in the 1st steps prezi (http://bit.ly/OGAfst), now we show the other way. Please don't forget to give us a positive rating if you are satisfied with the software! If you would encounter any difficulty using the software, then check out our forum at http://forum.orthograph.net, there are answers for many raising questions related to OrthoGraph Architect. If you need a rapid answer to your question, then don't hesitate to contact us at info@orthograph.net, we will respond within 24 hours. Adding the 2nd Room There is an alternative way of adding the second room.



Tap on the drawing tool again, and you will get a floating form asking for the name, type and relative structure position of the 2nd room related to the first.

After tapping OK you can start to draw. Name the Room ...and name your room by editing the location list. Specify the structure level... Open up the room structure or rotate your iPad device to Landscape mode. Create the second room. You can setup a structure of the building like Building 1\Story 1\Room 1
This physical structure lets you survey several multistory buildings in one survey project, or creating zones inside a room with different flooring, or floor/ceiling level. Room Structure
Full transcript