Introducing
Your new presentation assistant.
Refine, enhance, and tailor your content, source relevant images, and edit visuals quicker than ever before.
Trending searches
Wrench Xylophone
Step Three
Step Two
I chose to spray paint the PVC pipe pink. This step isn't necessary; I just thought it would look nicer.
Step Five
Repeat this step on both ends of the pipes to connect them together.
Using a sharpie and a yardstick, make markings down the two PVC pipes every two inches. (Start at the 1 inch mark.)
Step Six
Drill two more holes each end of the PVC pipes for a total of eight.
Using wire cutters, cut a section off of a wire hanger and loop it through the holes on the end of the pipes.
Step Four
Drill a hole on every marking made.
Step Eight
Step Nine
Loop one rubber band around every two screws.
Conclusion
Supplies:
Place the wrenches in the corresponding section. C3 starts on the right hand side.
Step Seven
- PVC pipe
- Eleven wrenches
- Rubber bands
- Pink spray paint
- Tuner/ Piano
- Sharpie
- Yardstick
- Wire Hanger
Drill screws into the holes made in step four.
Step One
- Screws/ Screwdriver
- Wire Cutter
- Drill
With a hacksaw, cut the PVC pipe in half so that each pipe is 20 inches long. The diameter of the pipe is 1 inch.