Create your own polished presentation in minutes. Just describe what you need.
Free to try, no credit card requiredSpecifications
N1738K
40"
Designed By: Adam Brzyski, Andrew Parasch, & Kristen Fleher
Weight: 353 grams
Wing Dihedral: 10°degrees
Height: 4.25"
Max Takeoff Weight (Lift): 442 grams°°
Parts of the Plane
Boeing Engineering Challenge D3 Objectives
Nose Cone/Vacuum Chamber
Nose Cone Cap
34"
Wings
Airfoil: GM15SM
Team Flyin' Squirelz Presents...
Fuselage
Empenage
Control Surfaces
Equal Surface
Area
surfaces in place
consistent flights
surfaces
Vertical Stabilizer
Horizontal Stabilizer
Materials
ABS Plastic (3D Printing): Nose Cone, wing ribs, Empennage, Control Surfaces, Vacuum Chamber Extension
Carbon Fiber Tubes: Wing Support Structure & Fuselage
Foam: Backup Wing, Nose Cone Cap
Clear Packing Tape: Covers Wings & Empenage
Balsa & Bass Wood: Wing’s Leading & Trailing Edges, Wing Base, Wing Support Structures, and Wing Ends
Magnets: Attach Wing to Fuselage
Spec Test, Static Load Test,
& Static Balance Test
Hot Glue, Super Glue, & Epoxy: Bonds surfaces together
O-Ring: Seals Ping Pong Ball to Vacuum Chamber
Rubber: "Y" Valve & One-Way Valve
Vinyl Tube: Connects vacuum chamber to “Y” Valve
Needle: Used to remove air from One-Way Valve
Nose Cone
Vacuum Pump: Creates Vacuum
Air Leaking into vacuum chamber
Hybrid between MonoKote and Tape for wings
Tape all surfaces
Fix Attempt
Result
MonoKote all surfaces
Allows to check for damage inside wings and holds desired shape
Idea
If touched together, tape would stick to itself and not hold shape
Exceeded desired weight
Verdict
Wings
Better results but still not air tight
Holes formed in glue
Air tight chamber
Wrapped in electrical tape
Coated in hot glue
Reprinted with fill density on 75% vs previous 10%
-Horizontal stabilizer too thin for tape on both sides
-Used paper on bottom and tape on top to avoid tape sticking to itself
-Tape worked well for vertical stabilizer
Covering Surfaces
Empennage
Manufacturing of the N1738K
Vacuum Tube System
Idea #1 -- Make valve to seal chamber when taking pump off of tube and placing finger on tube
Result-- Too complex for 3D printer and fitting part not found in local stores
--Printed Parts in halves then later glued together
- Proved to hold well and keep desired shape
Idea #2 -- Use a Y connector with one end sealed with a sports ball valve and the other with finger
Result-- Works well with make shift needle adapter for vacuum pump
--Attempted to adapt design to printer limitations
-Design integrity decreased
3D printed ribs
Solution
Segmented trailing edge between ribs
Placed tapered wood in indents in tips of ribs to use natural airfoil for leading edge
Use ribbed wings with leading edge bass wood
Design too complex for 3D printer
Second Iteration: Balsa Wood
--Smaller, more compact, and much more stable
Empennage
Wings
Time Line
First Iteration: Foam
-- Too flexible to keep consistent 10 degree dihedral
Wing Base
Problem
Balsa wood ribs broke easily
Trailing edge too thin to make in one piece
Leading edge not matching airfoil
More dense nose cone will increase plane momentum causing more damage to foam wings
4/26
4/27-5/5
5/6
Final Flight
Test Readiness
Review
Minor Adjustments
to Perfect Flight
Create your own polished presentation in minutes. Just describe what you need.
Free to try, no credit card required